Caple C804C Dokumentacja Pobierz pdf (Strona 145)

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier MN/HPOD.IOM

Appendix C Revision 8

C–3

C.2.2 Install the New Power Supply

To install the new power supply, do these steps:

Step

Task

Visually inspect the exposed SSPA heat sink for any debris or blockage. Use compressed air to clean

and clear as needed.

Visually inspect both the SSPA and power supply connector for cleanliness or damage. Clean and

correct as required.

Inspect the gasket for damage. Replace as required.

Install the power supply onto the SSPA. Make sure that the guide pins and connection are properly

aligned. Gently press to engage the connector.

Tighten the four captive fasteners where shown previously in Figure C-1.

Be sure to use an appropriate screwdriver, such as the one provided

with the SSPA, to avoid damaging the fasteners.

Reconnect the HPOD SSPA to its power source.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150

Brak uwag

Caple C804C Dokumentacja Strona 145